Floor Graphic Installation Instructions

Trim off the top half of the liner.

Floor graphic installation instructions.

Second make sure the edges of the graphic are not along a tile edge grout or floor joint. Floor graphic application instructions. You must follow some orderly instructions to get everything to turn out right. Generally floor graphics can be applied to waxed vinyl sealed concrete marble ceramic tile sealed wood and terrazo according to 3m.

Now after you ve aligned the graphic turn the graphic face down. 1 thoroughly clean the intended surface removing any grease wax and dirt with a mild detergent or solvent. Avoid aligning the edges of the graphic on the grout. The floor surface must be secure and in good condition.

To start lay the decal on the floor and use a strip of painter s tape across the entire length of the decal to hold it in place as you work. Fold back one end of the graphic. Installation instructions position the panel on the floor. So let s get on with it.

Measure and center your decal in desired area. Starting by the tape squeegee from the middle to one. 3 without touching the adhesive peel fold down and crease the release liner approximately 1inch from the top of the. 2 mark the desired floor graphic position.

Spray the floor area where the graphic will be applied. Here s how to begin. Thoroughly clean surface before installing the floor decal. Apply a center hinge using tape.

We ll discuss each of these individually. Use a solution of 20 drops of detergent per pint 400 ml of. Vacuum the rubber flooring to ensure that it is free of all dust lint and any other particles. But that s not the only condition.

A decal is easy to install. First locate the exact position on the floor where the graphic will be located. Installation must be performed by a licensed professional installer. Floor graphics are a great way to direct traffic inside the store right up to the sales counter where a strategically placed graphic can help seal the deal with a shopper.

After measuring tape the floor decal in place making sure it looks centered. At this point the liner should still be on. Beyond wayfinding and promotional opportunities floor wraps have the ability to transform an interior space into a completely new environment. General installation instructions floor graphics 1.

Squeegee made for applying vinyl 2. Ruler or measuring tape 4. Peel graphic from the liner. Tools the list below outlines the necessary tools and materials you ll need to install your graphic correctly.

Remove part of the decal from backing paper. Before you set out to install a floor graphic you need to be sure the vinyl will stick to the flooring material. To clean the floor use the following procedure. Clean the rubber floor surface with a warm soapy water mixture using mild dishwashing liquid.