Floor Finish End Different Slab Revit

I can make something similar with a mass but both masses and in place families trim the edges of the slab at a 90d angle to the bottom of the slab.

Floor finish end different slab revit.

By default pick walls is active. Editing hollowcore slabs in revit structure. Architectural draw the floor boundaries using one of the following methods. Now take a look to our floor slab edge and ceiling edge.

Steelwork is straight forward i e i shall place it on a named ref plane. Floors though i cant put onto a named plane. Unfortunately thou if you dont end with a riser in revit you cant join the stair to the floor so in plan you get an extra line which is increadibly confusing and dangerous. Your need to click finish several times to end this.

My thought is that one shoudnt end stairs with a riser when you have conrete slabs since its harder for the contractors to pour the slab with a nice and neat sloped edge. You can change location line to decide if you want to draw the stairs based on the side or on the center of the run. Architecture tabbuild panelfloor drop down floor. An actual floor will trim it vertical and thus give me a nice join with the piece of slab next door.

Sweep is created from a profile and path. Inside your model you have a sweep. Architectural structure tabstructure panelfloor drop down floor. Whats the best way of doing this the most efficiently.

If you intend multiple floor finishes e g the bathroom floor might have tile finish and the living room floor finish might be wood each floor object with different finish must have an appropriate floor type. The variable layer thickness parameter of roofs and floors affects the shape editing tools in the following ways. The variable thickness parameter can be selected to modify the layer thickness of a roof or structural floor. Floor finish is specified via edit type edit assembly dialogue on that floor object.

So the entire slab slopes and also changes thickness along the way. Unless im missing something the only drawback or feature that is lacking is being able to apply this across multiple panels. Using 3d views in addition to plan views and sections is a great way to build and. 6 use 3d views and sections.

That s the object hierarchy. Finish and your done. I have a floor that has a slope of 1 60 on it. You may modify the end of slabs as reqd or cut a hole in the middle of the slabs.

You can also change the actual run width to go above the minimum you specified previously. You can purchase this revit tutorial compilation in an e. When there is no variable thickness layer the whole roof or floor slopes and maintains constant thickness between parallel top and bottom faces. Materials floors and floor finishes.

The floor may change in the near future. With that all the steelwork will change and i dont fancy modelling stuff twice. Then click finish model.